Cleanroom Partition Wall

One partition, fully specified

This page covers the partition wall as a single unit: its construction, its joints and its finish. The supporting phrase clean room partition wall is used here for the same unit and does not have a separate page. If you are specifying one partition — for example, to divide a laboratory suite or to separate a ward zone — this is the page to work from.

A single partition still needs the full system decision: construction, joint and surface. A partition specified by panel name alone may arrive without the runners and joint pieces that make it a wall, so the enquiry should always confirm the delivery scope as a system.

Specifying a partition

Selection starts from the room, not from a single panel. List the rooms first — ward, production area or laboratory — then match each room to a wall construction, a joint type and a surface finish, and confirm the shortlist before ordering.

State both rooms the partition separates, the services that pass through it, and the finish required on each face. Confirm whether the partition must be removable or reconfigurable, and confirm the joint type at its ends and at any door opening in the run. Then send the partition schedule for confirmation before ordering.

Corners where a partition meets another wall are covered in the node index. Check the corner and junction nodes that apply to your partition before ordering, and note that drawing dimensions are not republished here — construction references remain the original drawings.

Back to the Cleanroom Wall Systems home page