Pharmaceutical Cleanroom Wall System

Pharmaceutical wall requirements

Pharmaceutical production areas place the heaviest demands on wall joints and surfaces. Joints must be tight and cleanable, surfaces must tolerate repeated cleaning, and the wall must not create dust traps at corners, junctions or service penetrations. The wall system for such a room is therefore chosen joint-first as much as panel-first.

The company application profile lists biopharmaceutical plants among the focus areas for its handmade panel, and pharmaceutical production among its general cleanroom applications. The customer guidance profile also notes that biopharmaceutical projects tend towards panels described as antibacterial, dust-free, tightly jointed and easy to clean. That guidance is used here as customer guidance, attributed as such, not as a measured performance claim for any panel.

Planning pharmaceutical walls

Selection starts from the room, not from a single panel. List the rooms first — ward, production area or laboratory — then match each room to a wall construction, a joint type and a surface finish, and confirm the shortlist before ordering.

Separate production rooms, preparation areas and circulation zones in the room list. Confirm the joint type and surface for each zone, mark every service penetration, and confirm which panels carry pre-installed conduits or pre-cut openings. Then send the room list for confirmation before ordering, and please confirm minimum order quantity and lead time before ordering.

This application page makes no compliance claim. A guide page on this site discusses good manufacturing practice frameworks as a guide topic only; it does not claim that any panel complies with any framework. If your project specification requires a particular document, raise it at enquiry stage so it can be confirmed for your exact order.

Back to the Cleanroom Wall Systems home page