Routine
Maintain the face and the joint, not the face alone. Joints collect dirt first, so a cleaning routine that ignores joints will leave the wall looking clean on the face while the joint deteriorates. Clean corners, junctions and service penetrations as part of the same routine, and inspect them during cleaning rather than on a separate schedule.
For handmade runner-edged walls, a single damaged panel can be removed and replaced without disturbing the surrounding wall. For machine-made jointed walls, maintenance focuses on the joint seam as a run. Either way, the maintenance routine should be planned when the wall is specified, not discovered after handover.
Planning maintenance at specification stage
Raise the cleaning routine and the service-access requirement in the enquiry, so the wall system confirmed for your rooms supports the routine you will actually use. Confirm which panels must be removable, which joints must be accessible, and which surfaces suit the cleaning agents your team uses.
The company service profile describes after-sales support with ongoing technical support and maintenance advice. Use that support at specification stage as well as after installation: a wall system confirmed with maintenance in mind costs less over its life than a wall specified on appearance alone.
Send your wall layout and room list — confirm panel type, joint and colour for each ward, production or laboratory zone before you order.
Send a wall-system enquiryPlease confirm minimum order quantity and lead time before ordering.